I’m new to this so bare with me… I drive a 92 Integra GS.
I getting my cr-vtec installed in a week. I wanna know what my numbers would be (horsepower, torque and 1/4…) Keep in mind that this is a daily driven car so it has a full interior. I have the following mods…
-B20B bottom end
-SIR head
-J.E. 12.1 pistons
-crower rods
-crower valvetrain, but with Ferrea valves
-knife edge crank and lighten flywheel
-custom chip
-act stage 2 clutch
-VAFC
-gsr tranny
-underdrive pulley
-fuel pressure reg.
-dc 4-2-1 header
-custom intake and exhaust
-aem cam gears
I also have all the necessity ( oil/fuel/water pump, gaskets, oil pan, etc…) The throttle body, intake manifold, and cams are B16 stock, but will upgrade later on…many thanks to all the people who respond…
I have an idea of what to expect. I from Toronto and I know that you guys(US) have more knowledge about b20’s. I would think you guys have more b20’s on the street then here…
dang and i thought getting just crvtec was good…jeez how much that gonna cost? bc my crvtec swap cost 5000 but i had a auto and is now a 5spd so that added an extra penny or two
to answer ur question…i have no idea…does anyone know how much hp just crvtec has???