Ok so a few years back i ordered some jdm rear seats from passwordjdm. Well it must have been their last set, or they where too dumb to notice, cause they sent me two drivers side upper peaces. Back when i ordered them i waited a month and then decided to install them and thats when i noticed they where the same part. Unfortunatly for me pjdm has a 30 day return policy and when i sent their service department an email about this they didn’t even respond to me. Well its a few years later and i still have these things sitting in my closet and i can’t sleep so i decided i would try to figure out if i could just pull out the plastic housing in the seats that the rods on the head rest hook into so that i could swap it into my car. I tried just pulling them out but they are in there pretty solid.
What im wanting to know is if anyone has done this before and if they know if there is some sort of pin or screw holding these things in or if i just need to pull out my guns and apply more pressure to pull these things out.