Are the drop spindles a made by a company in detroit, I emailed them once but Customer Service did nothing for a reply
http://www.heldmotorsports.com/Contact/index.htm
it said grand rapids, mi on the contact information. i guess that could be in the detroit area but im not from there so i really dont know. they havent replied to the email i sent them. suckass support, or perhaps they get a lot of people emailing them asking about them and the prices that never buy stuff. who knows. i can get the car as low as i want it with just a little preload on the front so i dont need them anyway. from what i understand from my research thats good for dragstrip action and doesnt hurt handling. i think im just gonna powdercoat my stockers and install the king wheel bearings.
i sent an email to them over 6 months ago and they didnt respond shit, it was swomething about fitment and prototypes for a five lug accord oh well no support for garbage customet service.
yea if you could engineer one, you could engineer them all. definately bs responses. look at it… its a fabricated piece. there isnt anything cast there. there isnt any “custom one-off tooling” that they have to invest in that should make it cost anymore than the ones they have currently available. all there is there is a slightly, and i meant very slightly, different set of design variables… the same raw materials more than likely could generate a g2 spindle from the same parts they make ef and dc spindles out of, right? ef and dc spindles will bolt up even if they throw the geometry off, so everything is there, with a few height differences in a few places. maybe they dont have a market, i bet they could sell three or four sets. id buy a set if they wouldnt fall apart.