Just got these in the mail today. I’ll post a pic when those are installed. Skunk2 is you’re wondering.
Update on the wire tuck: I had a minor surgery on Thursday so I haven’t made anymore progress, but will hopefully have some more pics soon.
Made some progress yesterday with the wire tuck.
Finally got the dash removed:
[img=http://s9.postimg.org/ykkfar7a3/image.jpg]
Removed the ac and fan boxes:
[img=http://s17.postimg.org/3s8h6v463/image.jpg]
Got the harness pulled through and the loom off:
[img=http://s10.postimg.org/lxt8kdwol/image.jpg]
I was hoping to finish the passenger side but it got too cold. Hopefully I can finish it up by the end of the weekend and get the drivers side started on.
Got all the wires through and placed. I still have to cut all of the abs wires and extend some, but ran out of time tonight.
Here’s some pics:
I’ve gotta get some wire numbers before I can run these through. I was going to pull them through the firewall but it looked like a huge pain in the ass so I’m short cutting it a little bit. I’m really not that worried about it though:
Done! Don’t mind the dirt. I’m gonna clean it when the motor gets pulled. I still have to put the dash back in but should be easier then it was coming out.
Got my id2000’s today
Hell yes man
Teaser pic of the block. Should have more progress soon:
It’s been quite some time sense I have posted anything, mainly because I’ve gotten lazy and haven’t had the time with a growing family and work. Sorry for the excuses, but here’s a pic of the block, rods and crank on the operating table.
